Investigation on CR, MRR and SR of wire electrical discharge machining (WEDM) on high carbon steel S50C
The purpose of this project is to study the encouragement of three machining parameters on wire electrical discharge machining that consist of peak current (IP), pulse OFF time (OFF) and wire tension (WT) to three machining responses which are cutting rate (CR), material removal rate (MRR) and surfa...
الحاوية / القاعدة: | Jurnal Teknologi |
---|---|
المؤلف الرئيسي: | 2-s2.0-84943270190 |
التنسيق: | مقال |
اللغة: | English |
منشور في: |
Penerbit UTM Press
2015
|
الوصول للمادة أونلاين: | https://www.scopus.com/inward/record.uri?eid=2-s2.0-84943270190&doi=10.11113%2fjt.v76.5701&partnerID=40&md5=55f5c149a81e271afaa0b88b6531f3f0 |
مواد مشابهة
-
Multi-objective optimization in wire-electrical discharge machining (WEDM) of titanium alloy
بواسطة: Saedon J.B.; Jaafar N.; Nor N.H.M.; Yahaya M.A.; Husain H.
منشور في: (2015) -
Influence of machine feed rate in WEDM of Titanium Ti-6Al-4V with constant current (6A) using brass wire
بواسطة: 2-s2.0-84901048392
منشور في: (2012) -
A review on current research trends in electrical discharge machining (EDM)
بواسطة: 2-s2.0-33947193401
منشور في: (2007) -
Investigation of Tensile Test on Back-to-Back Web Connection of Cold-Formed Steel C-Section
بواسطة: Muhammad Alif I.R.; Kamarudin A.F.; Seyed Hakim S.J.; Musa M.K.; Hamid S.; Mohammadhasani M.; Rathomy Romeli M.A.
منشور في: (2024) -
Investigation of Tensile Test on Back-to-Back Web Connection of Cold-Formed Steel C-Section
بواسطة: 2-s2.0-85200314989
منشور في: (2024)