Enhancement of Electrochemically Reduced Graphene Oxide (ErGO) UV Photo Detector Performance via Direct One-Step Electrode Deposition Technique

• Published in: INTERNATIONAL JOURNAL OF NANOELECTRONICS AND MATERIALS
• Main Authors: Khairudin, Norhazlin; Rahim, Muhammad Faiezzam; Ilias, Mohammad Haziq; Ramli, Norsyahirah; Manah, Muhammad Arman Abdul; Rani, Rozina Abdul; Zolkapli, Maizatul; Zoolfakar, Ahmad Sabirin
• Format: Article
• Language: English
• Published: UNIMAP PRESS 2023
• Subjects: Materials Science
• Online Access: https://www-webofscience-com.uitm.idm.oclc.org/wos/woscc/full-record/WOS:001141805800018
• ISSN: 1985-5761; 2232-1535

Recently, photodetectors have garnered significant attention owing to their broad spectrum of applications across fields such as the biomedical, industrial, agricultural, and telecommunications sectors. This research focuses on the development of a UV photodetector based on electrochemically reduced graphene oxide (ErGO) and incorporates reduced graphene oxide (rGO) thin films on interdigitated Au electrodes. The rGO thin films were synthesized using the direct one-step deposition method, maintaining a constant water bath temperature of 40 degrees C, and a consistent GO concentration of 0.15 g, while varying the pH levels within the range of pH 8 to pH 10. The investigation primarily concentrated on assessing the surface morphological, structural, and electrical properties of the rGO thin films by altering the pH level when exposed to 365 nm ultraviolet (UV) irradiation. The significant parameters for evaluating photodetector performance, including photosensitivity, stability, repeatability, response time, and recovery time. To achieve this, advanced techniques such as field-emission scanning electron microscopy (FESEM), Raman spectroscopy, and current-time measurement are employed. As a finding, the fabricated UV PD of rGO-Au at pH 9 achieved the photosensitivity 96.5% with the stability that was 30 times greater than rGO-Au (pH 10) and superior repeatability as well as rapid switching rate as compared to pH 8 and pH 10 with 0.6 V bias. This implies that rGO-Au prepared at pH 9 is a suitable material for application in UV detection.