| Summary: | One of the reasons why renewable energies are so attractive compared to fossil fuels is their low environmental impact. In addition, geothermal power plants contribute tremendously to sustainable energy generation for cities despite their lower energy efficiency than fossil fuel plants. The multi-heat recovery will eliminate the applicability defect mentioned. Therefore, this paper studies a novel tri-generation schema with the maximum use of heat loss through a multi-heat recovery technique in two principal processes, namely waste heat-to-power and power-to-H2 and -purified water. A double-flash binary cycle, Rankine cycle, electrolyzer unit, and reverse osmosis desalination system all play a part in the creation of this system. The technical feasibility of the system is scrutinized based on energy-exergy, environmental, sustainability, and exergoeconomic metrics and bi-objective optimization. Generally, 1st separator pressure made the strongest effect on the measured variables among decision variables. The increase in this parameter led to an upward-and-downward behavior of the net electricity and exergetic efficiency; while the cost of products experienced a converse trend. Also, the produced H2 and purified water together with the tri-generation gain output ratio augmented. Changes were not observed in net electricity and purified water with the change in 2nd separator pressure, but the H2 production rate changed significantly. Through bi-objective optimization, net electricity, purified water production rate, and total investment cost rate also significantly increase. Based on the optimum design mode, the CO2 emission rate and the sustainability index are higher than under the base case design. © 2023 Hydrogen Energy Publications LLC
|
|---|